3 element 70MHz Slot-Q - Slot beam antenna

2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
2_element_27MHz__51ef86ebdfef5.png
Manufacturer InnovAntennas

An exceptional 3el 70MHz beam antenna with high gain across a wide beamwidth - The 70MHz Slot-Q
Sales price £259.95
gross price
Sales price without tax £216.63
Sales price without tax£216.63
Tax amount £43.33
Total Tax: £43.33
Rear Mount
Rear Mount

Preloader

For Availability exact postage costs, please  This email address is being protected from spambots. You need JavaScript enabled to view it. - This antenna is in high demand so wait times will apply. Contact us to place an order without full payment now.

A 3el 70MHz low noise Slot-Q Yagi beam antenna with exceptional performance and ideal for noisy city locations. Super portable or contesting antenna too. New for 2023

2el 70MHZ Slot 2

 This product is provided with a G0KSC 2:1 Coaxial Balun 

Main Benefits of the G0KSC Slot-Q

  • More gain and similar length Yagi antenna
  • Gain provided over wider beamwidth than similar performing Yagi
  • more compressed down-facing lobes for less noise pick-up
  • Grounded loop 'dipole' for lower noise
  • High Front to Back ratio
  • NO Splitter required for stack a pair - just 2 lengths of 50Ω Coax!

What makes the Slot-Q different?

Lower noise for city locations

The Slot-Q is based upon the original slot beam design. A driven loop is used as is with LFA Yagis. However, this time the loop is placed horizontally and feed at either the top or bottom. 2 reflectors and 2 directors (per position, top and bottom of ther antenna) effectivley increase the height of the array, a little like a pair of close spaced Yagis with a common feed point. This provides extra gain by suppression of the elevation plane lobe that would otherweise have unwanted pattern both in an upward and downward direction. The suppression of the elevation lobe also reduces down-facing pattern which in return, reduces potential nosie pick-up from below the antenna (neighbours, houses, electrical systems, shack nosie etc.) so this is a win-win scenario!

Much more gain than a Yagi?

Yes! Per foot (metre) of boom, the Slot-Q gives a much higher gain figure with lower noise pick up.

How high does the Slot-Q stand?

2m band versions of this antenna stand 60-70cms high depnding on the model in question. The booms do not need to be large diameter and with the exception of the driven element (which is grounded opposite the feed point) all elements are insulated through the boom on 144MHz and 432MHz examples, electrically connected to the boom on all other bands.

Why is the driven loop connected to the boom?

The loop is fed by means of a G0KSC 2:1 coaxial loop balun, typically at the bottom of the antenna and across the boom. On the opposite side, the loop passes through and is electrically connected to the boom. Theoretically, this is a point of zero current (everything has been radiated) so just voltage at this point. This means, at the design frequency, this electircal connection is not be seen. However, the antenna feedpoint goes very high impedance very quickly either side of the design frequency. This provides a BPF (Band Pass Filter) property to the loop as well as a 'forced' balancing of the feed point for when coax cable is used to feed the antenna. The final benefit is having the driven element grounded means your receiver is better protected against static discharge related failures.

How much 'extra' gain does it have over other antennas?

It is not just the gain benefit that makes the Slot-Q exceptional, it is the vertical pattern suppression which adds an advantage too. Like Quads, the beneifts in terms of performance (over a convetional Yagi) decrease with boom length. Direct comparions are difficult to acheive as bandwidth and F/B would need to be identical to compare directly. This 5el displaces similar boom length to a much longer 4 element conventional Yagi yet delivers similar top-end gain although over a much wider 3dB beamwdith. All this with exceptional F/B at the same time.

Lots of gain over a wide 3dB beamwidth

Another benefit of the slot being short and having high gain is performance being spread over a wider beamwdith meaning less rotator turning is needed. With traditional Yagis, as gain increases, beamwidth decreases. With the slot you achieve the best of both worlds.

Is the slot still 50Ohm direct feed?

During Optimisation, the gain advantages of impedances below 50Ω on smaler examples were exceptional. Therefore the feed impedance is around 25Ω. For single antennas which are supplied with a G0KSC 2:1 coaxial balun. Note, As with all baluns and chokes we provide, there are no 'open' coaxial connections with infinate impedance behind any connector or socket other than where the terminals split to feed the antenna.

Can these slot Yagis be stacked?

Yes they can and with very good effect. Infact, they are far easier to stack than with most antennas because there is no need for any splitter nor 'special' impedance coax cable niether. Due to the native 25Ω impedance, a stacked pair of these slots can be connected together by means fo 2 x equal lengths of standard 50Ω coax (not 75Ω, 50Ω). These equal lengths do need to be odd quarter wavelengths (w/l) though. Help with this is provided in the manual. Additionally, any stacked pair would be fed on the loop side closest to one another. For example, top antenna fed at the bottom, bottom antenna fed at the top. This redcued coax lengths needed for any stack and of course, associated losses too. 

No addditional hardware or components (other than extra 50Ω coax) would be needed for the stack on the basis an N-type 'T' is provided with the antennas loop balun. As the loop balun is not needed as a part of a stack, the N-type 'T' used within this arrangement is used to join the coax from each antenna to your feed line.  Using the N-type T ensures there are NO open coaxial joins within or after any balun within the system. Another win-win!

Front to Back ratio and gain?

Typically, in most directional antennas to acheive higher gain levels, Front to Back ratio has to be given up. Likewise, if you want F/B, you need to give up a little gain. One advantage with the Slot-Q is it tends to deliver exceptional gain and F/B at the same time. Front to back drops off with the longer designs, this is intensional in order to maintain a gain advantage over a similar lenth Yagi which as mentioend above, drops off with boom length.

2el 70MHZ Slot 

The 3el Slot-Q on test with the provided coaxial 'Loop' Balun. rear mounted verson shown, centre mounted version also available.

Performance

Gain: 8.2dBi free space

3dB Beamwidth: 70 degrees

F/B: 20.14dB

Gain above ground: 13.87dBi @ 10m above average ground

Power Rating: 1.5kw

SWR: Below 1.4:1 from 144.00MHz to 145.00MHz  (for custom versions, 146MHz, 147MHz, 148MHZ or other, This email address is being protected from spambots. You need JavaScript enabled to view it.)

Stacking Distance: 2m 

2 Stacked Gain @ 3.5m spacing: 11.51dBi free space (17.04dBi 10m above ground)

2 Stacked F/B: 27.35dBi

Boom Length: Just 50cms long!

Distance between booms: 1.432cms

Weight: 2KG / 4.5LB

Turning Radius: 1.13m  (centre mount)

Wind Survival: 184KPH 

 2el 70MHZ Slot AN SOF AZ

A single 3el Slot for 144MHz with incredible F/B and gain over 70 degrees

 

2el 70MHZ Slot AN SOF EL

3el Slot elevation plot in free space

 

2el 70MHZ Slot AN SOF SWR

AN-SOF prediction for the 3el 70MHz Slot

 2el 70MHZ Slot SWR2

SWR as measured on the analyser


Copyright © 2024 Innovantennas. All Rights Reserved