6 element 24MHz LFA Yagi (12.9m)
Description
A 6 element High Performance LFA Yagi
The G0KSC LFA Yagi is a major step forward in the development of the Yagi Antenna, it provides a low-noise front-end for your radio so you hear more weak signals while at the same time maximising all round performance. This 6 element 24Mhz LFA provides stunning performance across the whole 12m band (24.800 - 25.00MHz). Hard to beat with a direct 50 Ohm feed-point and no matching losses and suppression of unwanted noise!! More information on the LFA Yagi can be found here.
NOTE: With all our HF antennas we can custom design your element taper and element size requirements in order to cater for all weather and installation requirements
Performance
Gain: 11.36dBi @ 24.930MHz
F/B: 29.29dB @ 24.930MHz
Peak Gain: 11.42dBi
Gain at 17m above Ground: 16.31dBi @ 24.930MHz
Peak F/B: 30.46dB
Power Rating: 5kw
SWR: Below 1.1.1 from 24.860 - 25.000MHz
Boom Length: 12.9m
Stacking Distance: 8 -10m (9m recommended)
2 Stacked Gain @ 9m spacing: 14.05dBi
2 Stacked F/B: 25.98dB
2 Stacked Gain @ 9m Spacing 12m above ground: 18.64dBi
Weight: 24.45Kg / 53.9LB
Turning Radius: 7.12m / 23.36ft
Wind Loading: 0.57 Square Metres / 6.17 Square feet
Wind Survival: 160KPH / 100MPH - A 125MPH (HD) version is available upon request
Other options available if higher wind loading/survival is required.
Specification
This antenna is made with elements that taper from 3/4 inch (19.05mm) to 5/8 inch (15.88mm) to 1/2 inch (12.7mm) and 3/8 inch (9.525mm) outer elements. The antenna has fully insulated elements which will ensure continuous, high performance for many years to come. Boom to mast brackets are included with all antennas which will support 2 inch (50mm) masts. Boom is 1.75 inch square (44.45mm) 10SWG (3.2mm) aluminum.
Our antennas are constructed with the best quality materials in order that the best mechanical construction can be achieved, not the cheapest and most profitable! Even a digital caliper is used (with an accuracy of .01mm) to measure the elements during production to ensure they are within 0.2mm of what they should be, ensuring they work as well as our software model predicts (VHF).
Note: Much development time has gone into our antennas, not just on basic electromagnetic design, we are able to model the effect of insulators, booms and other objects to ensure the make up of our antennas have least effect on performance and pattern degradation. More information can be found here
- Marine grade Stainless Steel Fittings*
- Original Stauff Insulation clamps
- Mill finished boom and elements for highest levels of accuracy
Azimuth Plot
Elevation Plot
Single 6 element LFA up 12m above ground
2 x 6 el LFA Yagi 9m apart with the bottom antenna 12m above ground
SWR
6 x 7el LFA Yagis at W7EW
Manufactured the right way, not the cheapest way!
*Where possible marine grade stainless steel is used.