2 element 50MHz LFA2 Yagi
Description
Prices 20% less for customers outside of EU
A 2 element low-noise LFA2 Yagi
The G0KSC LFA Yagi is a major step forward in the development of the Yagi Antenna; it provides a low-noise front-end for your radio so you hear more weak signals. This very compact 2 element 50Mhz LFA provides stunning performance across the important section of the 6m band (50.00 - 50.300MHz). Hard to beat with a direct 50 Ohm feed-point and no matching losses and suppression of unwanted noise!!
The LFA2 has a unique 'bent reflector' system installed which enhanced F/B and bandwidth of the antenna. This is an extremely compact antenna for these performance levels, especially when stacked!
Performance
6.67dBi @ 50.100MHz
13.31dB @ 50.100MHz
Peak Gain: 6.77dBi
Gain at 10m above Ground: 12.29dBi @ 50.100MHz
Peak F/B: 14.43dB
Power Rating: 5kw
SWR: Below 1.2.1 from 50.00MHz to 50.400MHz
Stacking Distance: 2.5-3.5m (3.25m recommended)
2 Stacked Gain @ 3.25m spacing: 10.02dBi
2 Stacked F/B: 33.04dB
2 Stacked Gain @ 3.25m Spacing 10m above ground: 15.5dBi
Boom Length: 0.726m
Weight: 2.1Kg / 4.63LB
Turning Radius: 2.079m / 6.82ft
Wind Loading: 0.12 Square Metres / 1.31 Square feet
Wind Survival: 185KPH / 115MPH
Other options available if higher wind loading/survival is required.
REAR MOUNT AVAILABLE UPON REQUEST AND REQUIRED FOR VERTICAL MOUNTING
Specification
This antenna is made with 1/2 inch (12.7mm) centre elements and 3/8 inch (9.525mm) outer elements. The antenna has fully insulated elements which will ensure continuous, high performance for many years to come. Boom to mast brackets are included with all antennas which will support 2 inch (50mm) masts. Boom is 1.25 inch square 16SWG aluminum.
Our antennas are constructed with the best quality materials in order that the best mechanical construction can be achieved, not the cheapest and most profitable! Even a digital caliper is used (with an accuracy of .01mm) to measure the elements during production to ensure they are within 0.2mm of what they should be, ensuring they work as well as our software model predicts.
Note: much development time has gone into our antennas, not just on basic electromagnetic design, we are able to model the effect of insulators, booms and other objects to ensure the make up of our antennas have least effect on performance and pattern degradation. More information can be found here
- Marine grade stainless steel fittings
- Original Stauff Insulation clamps
- Mill finished boom and elements for highest levels of accuracy
Azimuth Plot
Elevation Plot
Single 2 element LFA up 10m above ground
2 x 2el LFA Yagi 3.25m apart with the bottom antenna 10m above ground
SWR
The 2el LFA2
Manufactured the right way, not the cheapest way!